Hypalon Single Ply 10 Year Limited Product Warranty Requirements
The following links and information provide guidance in proper
application methods and document submittal procedures for issuance of
the "Inland Hypalon Single Ply Roof 10 Year Limited Product Warranty". This
warranty is not applicable to residential installations or any
installation under 100 squares in size unless pre-approved in writing
by Inland.
The "Attachment A" form should be used for pre-approval prior to
commencing any project under 100 squares.
Attachment A (pdf)
For proper application procedures, please refer to Inland
Specification #ISP275H and "General Requirements". We have also
provided a link for basic Spray Equipment Recommendations.
ISP275H Specification (pdf)
General Requirements (pdf)
Spray Equipment Recommendations (pdf)
Round Penetration Detail Drawing (pdf) (Viewable JPG version)
Ridge Cap Detail Drawing (pdf) (Viewable JPG version)
At project completion, please refer to the "Warranty Checklist". This
will ensure that all necessary information and documents are properly
submitted.
Warranty Checklist (pdf)
The following Warranty and Project Forms should be completed and
submitted to the Inland Coating Warranty Department. The product
warranty form must be the original, signed copy.
Hypalon Single Ply 10 Year Limited Product Warranty (pdf)
Project Profile (pdf)
All forms, product invoice copies and documentation should be sent to
the following address:
Inland Coatings Corporation
Warranty Department
P.O. Box 247
Adel, IA 50003
|
