Inland Coatings - Hypalon Single Ply 5 Year Limited Product Warranty Requirements

Hypalon Single Ply 5 Year Limited Product Warranty Requirements

The following links and information provide guidance in proper application methods and document submittal procedures for issuance of the "Inland Hypalon Single Ply Roof 5 Year Limited Product Warranty". This warranty is not applicable to residential installations or any installation under 100 squares in size unless pre-approved in writing by Inland.

The "Attachment A" form should be used for pre-approval prior to commencing any project under 100 squares.

Attachment A (pdf)

For proper application procedures, please refer to Inland Specification #ISP275H in addition to the "General Requirements". We have also provided a link for basic Spray Equipment Recommendations.

ISP275H Specification (pdf)
General Requirements (pdf)
Spray Equipment Recommendations (pdf)
Round Penetration Detail Drawing (pdf) (Viewable JPG version)
Ridge Cap Detail Drawing (pdf) (Viewable JPG version)

At project completion, please refer to the "Warranty Checklist". This will ensure that all necessary information and documents are properly submitted.

Warranty Checklist (pdf)

The following Warranty and Project Forms should be completed and submitted to the Inland Coating Warranty Department. The product warranty form must be the original, signed copy.

Hypalon Single Ply 5 Year Limited Product Warranty (pdf)
Project Profile (pdf)

All forms, product invoice copies and documentation should be sent to the following address:

Inland Coatings Corporation
Warranty Department
P.O. Box 247
Adel, IA 50003